Headgear/Facemask
Headgear
Headgear is often used to correct an excessive overbite. This is done by placing pressure against the upper teeth and jaw, which would hold the teeth in position or help move them into better positions. The severity of the problem determines the length of time headgear needs to be worn. The key to success with your headgear appliance is consistency. Headgear must be worn a certain number of hours per day, and if not, it must be made up the following day.
Headgear should never be worn while playing sports and should also be removed while eating or brushing your teeth.
Facemask
Often referred to as reverse-pull headgear, the protraction facemask is a removable appliance for patients where the upper jaw is not growing fast enough, resulting in a crossbite or underbite. The device consists of a metal bar attached to pads on the forehead and chin with rubber bands hooked to the facemask and the upper braces to gradually move the upper jaw forward. Patient compliance is extremely important as the facemask must be worn a set number of hours per day or more to obtain the desired results. The facemask device is generally worn for six to 12 months.
Nance Appliance
The Nance Appliance is used to prevent upper molars from rotating or moving forward after you’ve worn a headgear, a Wilson’s arch or any other appliance to move your molars back. Some patients wear the Nance Appliance while they are awaiting their bicuspids to grow into place.
The appliance is made of two bands that are cemented onto the first molars and a wire spans the roof of the mouth from one molar to the other. An acrylic pad or “button” covers the wire that touches the roof of your mouth directly behind your front teeth.
Patients should always brush around the bands daily. Do not eat sticky, chewy candy as it can loosen your appliance.
Distal Jet Appliance
The Distal Jet Appliance is a non-removable lingual appliance that is used to move upper teeth backward faster and more predictably than headgear. The Distal Jet distalizes molars and corrects teeth that have rotated. This appliance corrects class II problems.
The Distal Jet Appliance uses a solid track wire and two sets of locking screws on each side. The appliance is self-limiting by design because it has a distal stop attached to the tracking wire. The Distal Jet can be converted to a Nance Appliance by tightening the distal and anterior locks against the track wire and adding a Nance holding arch.
Pendulum Appliance
The Pendulum Appliance is used to correct class II malocclusions by distalizing upper molars. It’s used to correct the patient’s bite on the side of their mouth.
The Pendulum Appliance consists of a plastic “button” that touches the roof of the mouth and resilient wire springs that act in a broad swinging arc to move the molars back. The appliance uses the roof of the mouth as an anchor to move the molars back into their correct positions. Patients usually wear this appliance for 3 to 5 months.
Lip Bumpers
We like to avoid pulling teeth as often as possible, so we use lip bumpers on our patients who need to create more room for their crowded teeth. The lip bumper is a wire on the lower jaw that extends from one molar to another and keeps lips and cheeks from touching your teeth. When you move your mouth or speak, your lips and cheeks push on the bumper, and the bumper applies pressure to the teeth. This pressure pushes the molars back, creating more space for overcrowded teeth.
If you have a lip bumper, please remember to leave it in while eating, but do not eat hard or sticky foods. Proper, thorough brushing should remove any food that gets stuck in your lip bumper.
Pendex Appliance
The Pendex Appliance is a Pendulum Appliance that uses an expansion screw to widen the upper palate, correcting class II malocclusions and the patient’s bite.
The Pendex Appliance consists of a plastic “button” that touches the roof of the mouth. Within this button, there is a keyhole where you are to place the key and turn it according to your orthodontist’s instructions. This turning will widen the appliance, thus widening your upper palate. Patients usually wear this appliance for three to six months.
Interproximal Recontouring
Interproximal recontouring refers to a procedure in which Dr. Iwasiuk will reshape your teeth by sculpting the sides of the teeth. This can correct cracked, chipped, crooked or misaligned teeth. Instead of braces, crowns or veneers, you can choose to have interproximal recontouring to change the shape and look of your teeth to enhance your smile!